Sunme
Electronic component supply
Direct supplies from leading global manufacturers
PCB design
Printed circuit board design of any complexity
Software development
Embedded systems and microprocessor software
Import substitution
Replacing foreign components with Russian analogues
Supplier audits in China
On-site factory and supplier verification in China
Integrated supplies
Full cycle from components to finished product
Discuss project →
AboutCasesKnowledge baseFAQGlossary
RUConsultation
Sunme

Directions

Electronic component supplyPCB designSoftware developmentImport substitutionSupplier audits in ChinaIntegrated supplies
AboutCasesKnowledge baseFAQGlossary
RUSwitch language
Consultation
Sunme

Electronic component supply and technology solutions for your manufacturing

Services

  • Component supply
  • PCB design
  • Software development
  • Import substitution
  • China audit
  • Integrated supplies

Company

  • About us
  • Cases
  • Knowledge base
  • Careers
  • Contacts

Support

  • FAQ
  • Glossary
  • Privacy policy
  • Legal details

Subscribe to newsletter

Engineering materials, guides and cases every two weeks

© 2026 Sunme. All rights reserved.

Privacy policy
← Microbase|Microbase
NC7SZ126 — аналоги и замены | Microbase
Главная/Прочие/Разное/NC7SZ126

NC7SZ126

ON SemiconductorNeeds adaptationSOT23-5/SC70-5/XDFN1X1-6

Аналоги и замены (1)

OEM part number

NC7SZ126

ON Semiconductor

Прочие · Разное

CN part number

RS1G126

Run-IC

Прочие · Разное

Needs adaptationPin-to-PinSOT23-5/SC70-5/XDFN1X1-6
VCC 1.65-5.5VBuffer 3-state OE active HIGHIout +/-8mA (NC7SZ) vs +/-24mA (RS1G126)ten/tdis 1.5-5nsIoff-40 to +125Cpinout

Комментарии об отличиях

NC7SZ126 ↔ RS1G126

Single Bus Buffer Gate with 3-State Output, OE active HIGH. ВНИМАНИЕ: NC7SZ126 — ON Semi ULP. ON Semi NC7SZ126: Iout +/-8mA при VCC=3V (vs +/-24mA у RS1G126), tpd typ 2.3-5.0ns. RS1G126 — LVC family, более мощный драйв. При замене: возможен ringing при лёгкой нагрузке. ten/tdis (enable/disable time) у NC7SZ126 typ 1.5-4.5ns, у RS1G126 typ 1.5-5.0ns — близко. Подводный камень: OE active HIGH — при power-up, если OE floating или tied HIGH, выход активен. Для обеспечения Hi-Z при power-up: OE должен быть held LOW через pull-down резистор. Различие: при замене на RS1G126 добавить series resistor 22-33 Ом при длинных traces для supress ringing.

Информация предоставлена в справочных целях. Перед внедрением любого аналога обязательно сверьте технические характеристики, температурные режимы и сертификаты безопасности в актуальных даташитах производителей. Ответственность за финальный выбор компонента и его применение несёт инженер.